Filter
Top Products
10
Instructions for building-in the appliance
9. Fix cover (C) on guide (A) until it clips into
place.
13. Should the lining up of the furniture door
be necessary, use the clearance of slots.
At the end of operations, it is necessary to
check if the door of the furniture closes
properly.
10. Open the appliance door and the furniture
door at 90°. Insert the small square (B) into
guide (A).
11. Put together the appliance door and the
furniture door and mark the holes as indi-
cated in the figure.
12. Remove the squares and drill holes with Ø
2 mm at 8 mm from the outer edge of the
door. Place the small square on the guide
again and fix it with the screws supplied.
C
A
8mm
PR167
A
B
P
R168
8. Place guide (A) on the inside part of the
furniture door, upper and lower positions as
shown in the figure and mark the position
of external holes. After having drilled holes,
fix the guide with the screws supplied.
20mm
A
50mm