Filter
Top Products
4
DESCRIPTION OF THE APPLIANCE
E
F
D
C
B
A
H
G
A - Dairy compartment
B - Can storage shelves
C - Bottle storage shelf
D - Salad crispers
E - Glass shelf
F - Storage shelves
G - Bottle rack
H - Thermostat control
17
PR33
C
A
Fix cover (C) on guide (A) until it clips into place.
Open the appliance door and the furniture door at
90°. Insert the small square (B) into guide (A). Put
together the appliance door and the furniture door
and mark the holes as indicated in the figure.
Remove the squares and drill holes with ø 2 mm at
8 mm from the outer edge of the door. Place the
small square on the guide again and fix it with the
screws supplied.
8mm
PR167
A
B
PR168
PR167/1
D
B
Should adjustment of the furniture door be
necessary, use the clearance of slots as required.
At the end of operations, it is necessary to check if
the door of the furniture closes properly.
Fix cover (D) on guide (B) until it clips into place.
After completion of the door reversing operation,
check that the door gasket adheres to the cabinet. If
the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that
case, wait for the natural fitting of the gasket or
accelerate this process by heating up the part
involved with a normal hairdryer on a low setting.