Filter
Top Products
Water hardness Adjusting the water hardness
setting
Use of salt
°dH °TH mmol/l manually electronically
< 4 < 7 < 0,7 1 level 1 no
The water softener must be set in both ways:
manually, using the water hardness dial and
electronically.
Setting the water softener manually (see table)
Set switch to position 1 or
2
The water softener is factory set at position 2.
Setting the water softener electronically (see table)
The water softener is factory set at position 5.
The dishwasher must be switched off .
Press and hold the start/cancel button and turn
the programme selector dial clockwise till the
first programme.
Keep the button pressed until the programme
selector indicator light and the start/cancel in-
dicator light start flashing.
Release the button. The end of programme
indicator light will flash. The number of flashes
corresponds to current level set.
The end of programme indicator light might
flash 5 times, for example. The flashing is re-
peated every 5 seconds.
To change the level, press the start/cancel
button. Each time the button is pressed the level
increases. (Level 1 follows level 10).
The end of programme indicator light indicates
the new setting.
To memorize the operation, turn the pro-
gramme selector dial to position off.
8