Filter
Top Products
7
Property Damage: Join remaining tube
to cold water supply only.
A
5
■■ It is recommended that the water
connection be made using a shutoff
valve (not supplied).
■■ Where plumbing codes permit, a
saddle valve (not supplied) can be
used to supply water to the faucet.
Follow the directions for “self-
piercing attachments” included with
the valve.
FINAL WATER CONNECTION
Scalding Hazard: Steam and hot water can spit
forcefully from the spout if the temperature is set
too high at startup.
B
A
■■
Check all connections to ensure they
are tight
and that there are no leaks.
■■
Plug in hot water tank.
Water will be cold at first.
Allow 12-15 minutes for water to reach
target temperature.
Gurgling or hissing is normal during the
initial heating cycle.
Property Damage: A standard grounded outlet within
30" of the faucet is required under the sink. Do not
use an extension cord set with the dispenser.
FILL TANK & THEN CONNECT POWER
■■ Turn on the cold water supply.
■■ Lift handle to WARM position.
■■ Leave faucet open for at least
1 min. to fill the tank. Do not close
faucet until water is flowing freely
from the spout.
6
Nothing will happen until tank fills and
water begins running out of faucet.