Eurotech Appliances EDW254E Dishwasher User Manual


 
14
BUILDING A CUSTOM WOOD DOOR PANEL FOR MODEL EDW294E
If you prefer, you can build a custom wood door panel for this model to match the cabinets.
CUSTOM WOOD PANEL DIMENSIONS
Width: 23-3/8” (595 mm)
Height: 28-1/4 min. to 30-1/16” max.
(718 mm–764 mm)
(Measured from the top of the panel to the lower edge of the kitchen cabinet.)
Thickness: 1/4” (6 mm) minimum to 3/4” (19 mm) maximum
Weight: Up to 22 lb.
NOTE: Screws for mounting custom wood panels less than 3/4” are not supplied with the unit.
MOISTURE BARRIER
Among the materials supplied with your unit are two strips of moisture resistant material (moisture barriers).
One of these is intended to be affixed along the bottom edge of the back of the wood panel to prevent
possible moisture damage. You should have already attached the other moisture barrier to the underside of
the countertop.
CUSTOM WOOD PANELS THAT EXTEND TO THE CABINET TOP (30-1/16”)
With this installation, the custom panel extends 1-13/16” inches above the dishwasher
control panel, as illustrated at right.
This installation also leaves a 2” gap between the top of the dishwasher and the cabinet.
We recommend that you install the 2” fill strip that comes with the unit between the
upper edge of the dishwasher and the counter to hide the top of the dishwasher and
further reduce water noise.
NOTE: You will also need to build a custom wood toe kick to match the wood door panel.