Faber 5980410 Ventilation Hood User Manual


  Open as PDF
of 2
 
Side View
Cut-Out
Bottom View
Note: The Cristal HC comes standard in the top vent
position. The direct rear vent position can be achieved
by rotating the blower
housing.
Dimensional Diagrams
Rev.06/08
WARNING! Product specifications are subject to change without notification. Consult the installation instructions
before you begin installing this rangehood.
Custom Front Panel Dimensions
Make your ductrun as straight and
short as possible. The ductrun
should not exceed 35 equivalent feet
if ducted with the required minimum
of 6” round duct. Count 45º angles
as 3 feet, 90º elbows as 5 feet, and
90º flat elbows as 12 feet.
For best results, use no more
than three 90° elbows. Make sure
that there is a minimum of 24”
of straight duct between elbows
if more than one is used. Do not
install two elbows together. If you
must elbow right away, do it as
far away from the hood’s exhaust
opening as possible.
For more efficient airflow when
venting to the rear: Rotate the
Cristal HC blower housing so that
the 6” round exhaust outlet faces the
back, rather than running ductwork
up and elbowing back.
Pre-Planning Your Ductwork - Important: Consult the installation instructions before you begin installing this rangehood.
Recirculating Installations
Some ductwork must
be installed to exhaust
the rangehood back
into the kitchen, either
at the top of the
cabinet or at the face
of the soft. A plastic
vent grate supplied
with the rangehood
can be used to cover
the duct opening. This
duct work must not
terminate into a dead
air space.
Front View
For installations where ductwork to the outside of your home is impossible or highly impractical
Charcoal Filters, which attach to the blower assembly, absorb smoke and odors.
cabinet
ceiling
6” round
duct
hood
cabinet
ceiling
6” round
duct
hood
soft
vent grate
vent grate
29 7/8” or 35 7/8”
3/4”
1 15/32”
Pre-Planning Your Installation - Important: Consult the installation instructions before you begin installing
this rangehood. The recommended height to install this hood off the cooktop is a minimum of 24” and a maximum of 30”
for maximum effectiveness. Also consult the cooktop manufacturer’s recommendation.
 previous