Filter
Top Products
Rev.06/08
upper
chimney
cover
lower
chimney
cover
canopy
cabinet base
x = distance from hood to cooktop
(varies depending on installation)
min - 24”, suggested max - 30”
also consult cooktop
manufacturer's recommendation
2 3/4” min
15
3/8” max
23
5/8”
2 3/8”
36”
x
min & max ceiling height examples
x = 30"
min
7'
10 3/4"
max
8'
11 3/8"
x = 28"
min
7'
8 3/4"
max
8'
9 3/8"
x = 26"
min
7'
6 3/4"
max
8'
7 3/8"
x = 24"
min
7'
4 3/4"
max
8'
5 3/8"
upper
chimney
cover
ductless
lower
chimney
cover
canopy
cabinet base
x = distance from hood to cooktop
(varies depending on installation)
min - 24”, suggested max - 30”
also consult cooktop
manufacturer's recommendation
8
3/8”
min
15
3/8”
max
23
5/8”
36”
x
min & max ceiling height examples
x = 30"
min
8'
4 3/8"
max
8'
11 3/8"
x = 28"
min
8'
2 3/8"
max
8'
9 3/8"
x = 26"
min
8
3/8"
max
8'
7 3/8"
x = 24"
min
7'
10 3/8"
max
8'
5 3/8"
12
1/2"
2
3/8”
3
1/2”
The ducted Stilo Isola chimney can be adjusted for ceilings between 7’ 4 3/4” and 8’ 11 3/8” depending on the distance between the
bottom of the hood and the cooktop (distance x in above DUCTED diagram). The ductless Stilo Isola chimney can be adjusted for
ceilings between 7’ 10 3/8” and 8’ 11 3/8” depending on the distance between the bottom of the hood and the cooktop (distance x in
above DUCTLESS diagram). For higher ceiling installations, the High Ceiling Chimney Kit includes an additional support structure which
adds 27 1/2" to the various ceiling heights in the gures above.
Ducted Ductless
Dimensional Diagrams
Ducted Ductless
WARNING! Product specications are subject to change without notication. Consult the installation instructions before you
begin installing this rangehood.
Pre-Planning Your Installation - Important: Consult the installation instructions before you begin installing this rangehood.
Make your ductrun as straight and short as possible. The ductrun should not
exceed 35 equivalent feet if ducted with the required minimum of 6” round
ductwork. Count 45º angles as 3 feet, 90º elbows as 5 feet, and 90º at
elbows as 12 feet.
For best results, use no more than three 90° elbows. Make sure that there
is a minimum of 24” of straight duct between elbows if more than one is
used. Do not install two elbows together. If you must elbow right away,
do it as far away from the hood’s exhaust opening as possible.
Pre-Planning Your Ductwork - Important: Consult the
installation instructions before you begin installing this rangehood.
Ductless Installations
For installations where ductwork is
impossible or highly impractical, a
Ductless Conversion Kit is available.
Charcoal lters, which attach to the
blower assembly, absorb smoke and
odors. A ductless diverter directs the air
out to a lower chimney with vent grates
cut into the sides.
* it is highly recommended that
professional style cooking always be
vented to the outside.