Filter
Top Products
16
/0%2!4)/.34/"%0%2&/2-%$7(%.
35"34)454).'4(%).*%#4/23
Ć Remove the gratings, the burner covers and the knobs;
Ć Using a wrench substitute the nozzle injectors „J‰ (fig: 5.4 - 5.5)
with those most suitable for the kind of gas for which it is to be
used.
4HEBURNERARECONCEIVEDINSUCHAWAYSOASNOTTOREQUIRETHE
REGULATIONOFTHEPRIMARYAIR
fig. 5.4
).*%#4/234!",%
2%'5,!4).'4(%"52.%2-).)-5-3%44).'
When switching from one type of gas to another, the minimum flow
rate must also be correct: the flame should not go out even when
passing suddenly from maximum to minimum flame.
To regulate the Âflame follow the instructions below:
Ć Light the burner
Ć Set the gas valve to minimum
On gas valves provided with adjustment screw in the centre of the
shaft (fig. 5.6) Using a screwdriver with max. diameter 3 mm, turn
the screw inside the tap until the correct setting is obtained.
For LP/PROPANE gas, tighten the adjustment screw completely.
After regulation repeat the operations indicated in paragraph „2.
Pressure regulator‰ at page 12.
If the cooktop has been disconnected and then connected again to
the gas supply line repeat the operations indicated in paragraph „5.
Leak Testing‰ at page 14.
TOOLS NEEDED
A = T-handle wrench
B = wrench
C = screwdriver
A
J
B
J
C
./-).!,
0/7%2
2%$5#%$
0/7%2
,002/0!.%
7#0
.!452!,'!3
7#0
"52.%23 "45HR "45HR
INJECTOR
MM
"YPASS
MM
INJECTOR
MM
"YPASS
MM
!UXILIARY! ADJUSTABLE
3EMIRAPID32
ADJUSTABLE
2APID2 ADJUSTABLE
4RIPLEBURNER4#
ADJUSTABLE
fig. 5.5
fig. 5.
6
Save the orifices removed from the appliance for the future use