Filter
Top Products
11
TROUBLESHOOTING GUIDE
You can solve many common Wine Cooler problems easily, saving you the cost of a possible service
call. Try the suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
POSSIBLE CAUSE
SOLUTION
Cooler does not
operate.
Not plugged in.
The appliance is turned off.
The circuit breaker tripped or a blown fuse.
Plug the unit in.
Press to turn on the unit.
Check the breaker and/or fuses.
Cooler is not cold
enough.
External environment may require a higher
setting.
The door is opened too often.
The door is not closed completely.
The door gasket does not seal properly.
Check the temperature control setting.
Close the door properly.
Check the door gasket.
The compressor
turns on and off
frequently.
The room temperature is hotter than normal.
A large amount of contents has been added
to the cooler.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
Close the door properly.
Check the door gasket.
The light does not
work.
Not plugged in.
The circuit breaker tripped or a blown fuse.
The light button is “OFF”.
Plug in the unit.
Check the breaker and/or fuses.
Vibrations.
The cooler is not levelled.
The bottles are vibrating.
There is an object under the cooler.
Check to assure that the cooler is level.
Make sure the bottles don‟t touch each
other.
Remove the object.
The cooler seems to
make too much
noise.
The cooler is not level.
Level the cooler.
The rattling noise may come from the flow
of the refrigerant, which is normal. As each
cycle ends, you may hear gurgling sounds
caused by the flow of refrigerant in your
cooler. Contraction and expansion of the
inside walls may cause popping and
crackling noises.
The door will not
close properly.
The cooler is not level.
The door was reversed and not properly
installed.
The gasket is dirty.
The shelves are out of position.
Level the cooler.
Close the door properly.
Clean the door gasket.
Place the shelves properly.
Error Code:
E0-E1-E2
HH-LL
Error codes.
Contact us for a service call.