Filter
Top Products
WHA
T
T
SHOUL
D
D
YO
U
U
DO?POSSIBL
E
E
CAUSESPROBLEM
You have doubts about whether your hob is working correctly. This does not
necessarily mean that there is a breakdown. Nevertheless, check the following
points.
Contact your service agent.
Have the connection checked
first. If the connection is OK,
contact your service agent.
This is a normal occurrence.
Use another utensil suitable for
induction cooking.
Check your beakers (fuses)
and/or connection cable.
If OK, contact your service agent.
When you switch the unit on, the
supply-line breaker trips off or the
supply-line fuse burn.
When you switch elements on, only
one element works.
Your hob makes faint clicking noise
when in operation.
The fans keep running for a few
minutes after the unit has been
switched off,
After turning an element ON and
having utensil placed on the coil,
there is no heat and the digital
indicator continues flashing..
The unit doesn't work at all.
The top of the unit is always
lukewarm (even when elements are
not switched on).
This is a normal occurrence.
This is a normal occurrence.
Utensil makes noise during cooking.
Under high power this
phenomenon is normal with some
types of pots and pans. There is
no danger for the hob.
Use each heating element for an
hour with a pan filled with water.
Your unit may be connected
incorrectly,or there is an
internal problem.
There is an internal problem
with the unit.
This noise occurs when the power is
being shared between two
induction coils.
The electronics are cooling
down
The utensil you are trying to use
is not compatible with induction
cooking or its diameter is under
10 cm. (4”).
There may be a power supply
or internal problem.
The electronic components are
under power and they create
heat.
Your utensil creates noise from
vibrations caused by induced
current .
A new unit
The hob gives off a smell when first
used for cooking.
If any crack on the vitroceramic glass can be noticed, or the glass
is broken DO NOT USE THE UNIT. Disconnect the electrical
supply to the unit by tripping the breaker off (if the unit is hard-
wired to the supply) or just unplug the unit (if there is a plug on
the supply cable).
Servicing of an induction unit is to be done by an authorized
service agent. Contact your dealer for service location closest to
your residence. Never try servicing the unit yourself.
4
/ SPECIAL MESSAGES, DIFFICULTIES
9963 77784
02/06