Filter
Top Products
O. TAPE IN - Unbalanced
phono (RCA) input jacks
designed for use with a tape
player, CD player, etc. These
jacks sum the stereo left and
right input signal to a mono
signal useful for playing
prerecorded music. The
tape/effects return to main and
tape/effects return to monitor control the volume to
these buses respectively.
P. TAPE OUT - Unbalanced phono (RCA) output
jacks designed for use with a tape recorder. They
produce a mono signal. The rec out knob controls
the tape out signal level.
6
Q. PA 1 OUT / PA 2 OUT - These are speaker level
output jacks designed to feed your main or monitor
speaker enclosures. Remember, the minimum
impedance load is 4 ohms. Connecting a load of
less than 4 ohms may result in unsatisfactory
performance such as overheating to the point of
thermal shutdown. PA 1 Out jacks are intended for
the main speakers. The use of the PA 2 Out jacks
depends on the position of the PA 2 Assign switch.
(See item E on page 5).
R.POWER SWITCH -
Turns the AC power ON
and OFF. When the switch
is in the OFF position, the
SRM 6302 / 8302 is
completely shut down.
S. SUPPLY CORD - This
is a grounding type supply
cord to reduce the
possibility of shock
hazard. Completely
unwind the cord from its
cord wrap to prevent
blocking air flow to the
transformer. Be sure to
connect the cord to a
grounded receptacle. DO
NOT ALTER THE AC
PLUG.
TAPE INPUT / OUTPUT JACKS
POWER
ON
OFF
R
REAR PANEL
OUT
IN
L
R
TAPE
O
P
S
PARALLEL SPK JACKS
150W
4Ω MIN TOTAL
PARALLEL SPK JACKS
150W
4Ω MIN TOTAL
PA 2
OUT
PA 1
OUT
Q