Filter
Top Products
Isotempâ Laboratory and Chromatography Refrigerators
Page 5 of 12
Part Number: 104416
Operation
Control Layout
The customer should have the wall receptacle and circuit checked by
a qualified electrician to verify the receptacle is properly grounded
and meets power requirements specified on the data plate.
WARNING: DO NOT
under any circumstances cut or
remove the third (ground) prong from the power cord. DO
NOT use a two-prong adapter plug.
Where a two prong wall receptacle is encountered, it is the personal
responsibility and obligation of the user to have it replaced with a
properly grounded three prong receptacle.
CAUTION: Do not use an extension cord. Use of an
ungrounded cord or an overloaded circuit VOIDS the
compressor warranty.
WARNING: If the unit is tilted in excess of 30 degrees, level
the unit then wait at least 12 hours before applying power to
it.
WARNING: This product is not approved for storage
of flammable or explosive materials. Also, it is not
approved for use in hazardous locations containing
explosive atmospheres.
Before operation, become familiar with the refrigerator controls
located on the refrigerator header panel. A layout of the control is
given below.