Filter
Top Products
Laundry
Washers
Dryers
Under Counter Installations
These units can be installed in free-standing installa-
tions. This shows the traditional built-in layout: dryer
on left and washer on right. To reverse this, simply
reverse the installation specs. These units can also be
built in under a 34" to 35" high counter. The
minimum counter width is 49" for a pair. This 49"
width allows 1/2" of space on the outside edges and
between the units, otherwise units may bump
wall/cabinet or each other during spin cycles. This
also allows for sufficient air circulation for dryer.
Electrical, Water And Code Requirements
The washers have a 220 V line that plugs into an ASKO dryer or a standard 220 V, 20 amp single phase outlet. ASKO
dryers plug into standard 220V, 30 amp circuit. The washers connect to the cold-water outlet. The water pressure must be
between 15 – 146 PSI. Second floor (above grade) installations must meet all local building codes.
See Use & Care Guide for detailed installation instructions.
23-7/16"
33-1/2"
to 34-1/2"
23-7/16" or 24-7/16"
23-7/16"
33-1/2"
to 34-1/2"
23-7/16" or 24-7/16"
23-7/16" or 24-7/16"
67" to 69"
23-7/16"
Depth with Door Open
W6021 — 36-3/8"
W6441 & W6661 — 42-3/8"
Depth with Door Closed
W6021 & W6441 — 24-7/16"
W6661 — 23-7/16"
Depth with Door Open
46-1/16"
Depth with Door Closed
T701, T721 & T731 — 24-7/16"
T761 & T781 — 23-7/16"
5-1/2"
23-3/4" or 24-3/4"
49" Minimum
34"
to 35"
15-3/4"
Minimum
Hot &
Cold Water
4-23/32"
4-1/8"
Drain
Hole Diameter
5-1/2"
5-1/2"
220V,
30 Amp
Outlet
18
INSTALLATION