Filter
Top Products
7
IT IS THE CUSTOMERS RESPONSIBILITY:
It is the customers responsibility to ensure
that the product is electrically connected by
a qualified electrical installer in conformance
with the National Electrical code, ANSI/NFPA
70 (latest edition) and all local codes and
ordinances.
Copies of the standards listed may be
obtained from:
National Fire Protection Association
Batterymarch Park, Quincy,
Massachusetts 02269.
US
Installation instructions
Junction Box
location for
undercounter
installation
Junction
Box
location
for wall
installation
Unpacking the oven
IMPORTANT!
Do not use door handles or any part of
the control panel for lifting the product.
Before the product is lifted, the oven
doors and racks are to be removed.
1
Carefully lay the product on its back.
Remove the external wrapping and the
bottom polystyrene protector and pallet.
Stand the product up and remove all other
polystyrene packaging.
2
Remove the oven doors.
IMPORTANT!
Do not lift the door out by the handle
as this may cause damage to the
product.
Do not disengage the hinge hooks
when the door has been removed as
they are differcult to re-engage.
- Open the oven door fully.
- Lift the catches on both of the hinges
over towards you onto the hooks of the
hinge arm (see picture below).
- Raise the door slightly, holding on either
side near the handle, making sure that the
clips stay on the hooks.
- Lift the door out.
3
Remove the wire shelves and oven trays
by sliding them out. Use both hands to
remove each item. Remove the cardboard
packaging from the oven cavity.
Door Hinge
Door
Clip
Hook