Filter
Top Products
7
USING YOUR COOKTOP
IMPORTANT!
Turn the burner OFF and see ‘Troubleshooting’ for what to do next if you experience
any of the following:
●
There’s a strong gas smell.
●
The flame has been blown out by a draft
or extinguished by a spill and does not
re-ignite.
●
There is no clicking/sparking or there is
clicking/sparking, but a burner or burners
won’t light.
●
The flames don’t burn all the way
around a burner, or some flames flicker.
●
The flame is yellow or yellow-tipped
rather than blue.
●
The flames are too large, small, irregular,
noisy or lift away from the burner.
IMPORTANT!
●
If a dial halo is red, the dial is not in the OFF position.
Ensure that the burner has ignited or turn the dial back to the OFF position.
●
A white halo indicates that another burner dial has been turned on.
●
When all the dials are in the OFF position, all the halos will turn off.
Adjusting the flame on the dual work burner
1 Always start out on HI. Both rings of
flame will be on in the shaded setting
range.
Note: when turned all the way down,
the outer ring may appear to flicker. If
this occurs, adjust the dial slightly back
towards HI for a stable outer ring.
2 To use the inner ring of flames only,
continue turning the dial towards LO.
Only the inner ring will be on in the
shaded setting range.
Both rings
Inner ring only
EN