Filter
Top Products
36
START HERE
Press
to stop the beeping.
Try to open the drawer
(without using excessive force).
U1: Turn on the water supply,
then press
to resume the wash
program.
Check which program indicators
are lit on the wash program panel.
Look up what fault code the
indicators correspond to in the
table opposite.
Note down the code here:
Press
. The Eco indicator and another set
of program indicators will briefly light up on
the wash program panel. Mark which ones
in the diagram below. This information will
help Fisher & Paykel identify the fault more
precisely. Which other indicators light up
when you press
?
Press
. Wait a few
seconds, then press
again.
Press . Wait a few
seconds, then press
again.
YES
YES
NO
YES
YESNO,
IT’S
BLUE
NO, IT’S
BLUE
NO
If it’s a ‘U’ code
If it’s an ‘E’ code
Has the fault code disappeared?
Has the dishwasher resumed
normal operation?
Can the drawer be opened?
Is the light above the
button still red?
Is the light above the
button still red?
You have corrected the fault and can
continue to use your dishwasher as normal.
Disconnect the dishwasher from the
power supply (unplug or switch off at
circuit breaker), turn off its water supply,
then contact Customer Care with the
fault code information. See your ‘Service
and warranty’ booklet for contact details.
The fault
has reset
and you
should
now be able
to open the
drawer.
You can
continue to
use it as
normal.
How to attend to a fault ‐ Designer models
U4: Attend to the fault on
the other drawer. The drawer
displaying U4 is not faulty.
NOYES
U6: Open the drawer and check the
spray arm.
Has the spray arm loosened or
come off its mounting?
Water pressure
is too low. You
may need to have
a ‘4 litre’ valve
installed on your
water supply.
Refit the spray arm
following instructions
in section ‘User
maintenance
instructions’, then close
the drawer and press
to resume the wash
program.