Filter
Top Products
17
12b 13b
14b 15b
REMOVE THE DRAWER SECURE THE DRAWER TO THE CABINETRY
REFIT THE DRAWER ONTO THE RUNNERS
2
1
4
5
3
Before refitting the drawer,
ensure the hoses are not
twisted and the latches at
the rear of each drawer
runner are facing forward.
Ensure the release tabs on
both sides are reset fully.
Ensure the drawer
is now rotated
clockwise back.
2
100 mm
1
3
4
5
100 mm
To prevent kinked hoses, we recommend
rotating the drawer anti-clockwise and
resting it on its side after removal.
Press the release tabs
in on either side and
push back to release
drawer from runners
Push drawer runners back in.
Product may
move. Mark
chassis position
on cavity
1
2
The product has three
pairs of fixing points:
Ensure the sound insulation is
repositioned correctly.
a pair of fixing
holes either side on
the bottom
(use 38 mm fixing
screws & washers)
two pairs of formed
brackets on either
side of the chassis
(use 16 mm screws)
2
1
After routing the vent hose
through and out the hole
cutout, attach and secure the
vent by tightening the four
screws provided.
Airflow
Pull forward the release tabs
on both sides 100
mm
INTEGRATED MODELS WITH REMOTE (NZ AU) ONLY -
SECURE THE EXTERNAL VENT