Fisher & Paykel 525911L Dishwasher User Manual


 
32
FAULT CODE DISPLAYS
The Electronic Display shows when there is a fault. The DishDrawer will
continuously beep every second until the Power button is pressed.
The fault codes are as follows and we recommend that you check the chart below to
correct the fault where possible. If the fault code cannot be removed by pressing the
Power button, turn the power off at the mains supply, wait 10 seconds and turn the
DishDrawer on again. We would recommend the DishDrawer be run on a wash
program to ensure the fault has been completely eliminated. If the fault code still
appears, call your Fisher & Paykel Authorized Service Agent.
You are reminded that if you call a Fisher & Paykel Authorized Service Agent because
of a user fault, it is not covered by the Warranty. Should you encounter any problems
then we recommend that you telephone our Fisher & Paykel Customer Care Center on
1 888 9 367 872.
FAULT POSSIBLE CAUSE WHAT CAN BE DONE
CODE
U1 Fill Fault Excessive foam. Refer to Section on
Problem Solver.
Check the inlet hose is connected and
the water faucet is turned on.
Check the spray arm is placed on the
impeller correctly. Refer to Section on
User Maintenance Instruction.
Incorrect Installation Check the installation of the drain
hose(s) and ensure it is supported to
the recommended height above the
base of the DishDrawer.
Blocked Inlet Hose Check the filter in the inlet hose is not
blocked.
Very low water pressure Check the water pressure setting.
( < 4 psi ) Refer to Section on Option
Adjustment Mode.
Filter Plate and Spray Arm Check the filter plate is properly
incorrectly installed. locked securely in place and the
spray arm is correctly on the
impeller. Refer to Section on User
Maintenance Instruction.