Filter
Top Products
10
Using your dishwasher
If you have forgotten to load some dishes
To pause a wash programme (DW60CD models only)
1
Press the Power button.
2
Open the door slowly.
Important!
There is a risk of being sprayed with hot water. Do not open the door fully until the spray arm has stopped
rotating.
If the door is left open during the wash programme, the dishwasher will beep ten times every
thirty seconds.
When the dishwasher has been paused and the dishwasher has heated the water, leave the
door ajar for several minutes and then close. Otherwise, the dishwasher door may open due to
expansion.
If you want to change or cancel a wash programme
A wash programme can be changed if it has only been running for a short time. The detergent
dispenser may need to be refilled.
To cancel and reset a programme:
DW60CD models
Press the Reset button. One beep will sound, and all the programme indicators will light up to
indicate that the current programme was cancelled successfully. You can now select a new wash
programme.
DW60CS models
Press the Power button.
Memory function
(DW60CD models only)
If the power supply is switched off during a programme, or the Power button is accidentally
pushed, your dishwasher is able to remember the current setting and stage in the wash
programme. It will automatically return to the same stage in the programme, once power is
restored (or the Power button is set to ‘ON’), and will continue with the wash.