Filter
Top Products
20
To start a wash programme
1
Make sure that the dishwasher is powered on .
2
Check that the wash programme displayed is the one you would like to use. If not, see section
‘Changing the wash programme.’
3
Once the display shows the programme you would like to use, press to start the programme.
The display will show the approximate time remaining and the stage of the wash.
Note: the dishwasher will remember the last programme used.
To pause and restart a wash programme
1
Press to pause the programme.
2
Open the door very slowly.
Important!
There is a risk of being sprayed with hot water. Do not fully open the door until the spray arms have stopped
rotating.
3
Load, remove, or rearrange any dishes if needed.
4
Check that there is no excessive steam, then close the door.
Important!
If the programme is paused when the dishwasher has already heated the water, leave the door ajar for
several minutes before you close it again; if you don’t, the expanding steam inside could force the door
open.
5
Press to restart the programme.
Power/
Keylock
Start/Pause Scroll Display
Press briefly to
power on or off
or press and hold
for 3 seconds to
activate/cancel
Keylock
Press to start or
pause a wash
programme
Press to navigate
through menus
and options
Shows settings,
options, wash
programme
status,
fault codes and
instructions
Controls and starting a wash - CC models
CC MODELS