Fisher & Paykel HI120 Cooktop User Manual


  Open as PDF
of 7
 
OPTIMISING THE VENTSURFACE BY SELECTING COOKTOP TYPE
11
To ensure best performance, the type of cooktop under the VentSurface needs to be selected after installing the appliance.
To select the type of cooktop
1
Make sure the VentSurface is on stand-by (plugged into a power outlet which is switched on but the fan is off).
2
Press the and buttons simultaneously. A single horizontal segment will appear in the display.
3
Release and re-press the buttons simultaneously again to scroll through the types of cooktops:
Top segment – Gas
Middle segment – Induction
Bottom segment – Electric/Ceramic
4
To store the type of cooktop last selected, press the or button.
Gas Induction Electric
Ceramic
SELECTING FILTER MODE
12
After installation, the VentSurface has to be set to operate on aluminium mesh filter mode (if the extracted air is ducted outside) or carbon filter mode (if the extracted air is recirculated indoors).
To change between filter modes
1
Make sure the VentSurface is on stand-by (plugged into a power outlet which is switched on but the fan is off).
2
Press the button.
3a
The display will show the “-“ symbol, indicating that the VentSurface is set to aluminium mesh filter mode (external ducting).
OR
3b
The display will show the “C” symbol, indicating that the VentSurface is set to carbon filter mode (internal recirculation).
4
Press the button and hold down for at least five seconds to change to the filter mode you want. The filter mode last selected will be activated.
(2,1) -2- 599489D izona vsisland install A2 NZGB.indd 21/7/09 2:52:11 PM
(2,1) -2- 599489D izona vsisland install A2 NZGB.indd 21/7/09 2:52:11 PM
 previous