Filter
Top Products
4
Preparing the rangehood for installation
Ensure the overhead cabinets are built according to Fig.7 (below).
Before drilling any holes, check that the area behind the surface
to be drilled is clear of any electrical cables or pipes etc.
Recirculated installation
If the rangehood is to be installed as a recirculated hood,
first ensure the cabinets are built according to Fig.7 below:
1
Do not remove the knockouts shown in Fig.4. These are
removed for ducted options only.
2
Remove Cover Tape “A”. See Fig.4.
Note: for recirculation, please purchase a charcoal
filter (refer to Accessories list on page 2).
3
If a 70 mm handle is not installed (depending on model
purchased), remove front handle “B” by undoing the
3screws on the fascia (see Fig. 4).
4
Replace front handle “B” with the replacement handle “C”.
See Fig.7 for height of handle.
Ducted installation
If the rangehood is to be installed as a ducted hood:
1
Remove the appropriate knockout to suit top venting,
as shown in Fig.4
2
Do not remove Cover Tape “A”. See Fig.4. This is
removed for recirculating only.
Mounting the rangehood
Warning!
Failure to install the screws or fixing device in accordance
with these instructions may result in electrical hazards.
The rangehood can be mounted from the top.
Before commencement, unpack the rangehood and
check that it functions correctly.
Mounting to underside of cupboard
Fix the rangehood to a shelf mounted at the right height in your wall units, by drilling 4 holes,
6 mm in diameter, (see Fig.8) and fixing with the 4 screws supplied (found in the bag labelled
“TOP FIXING”). When installing the rangehood the space between the product and the wall shall
be covered with the adjustable lateral and rear spacer supplied (Fig.5 and Fig.6).
Installation instructions
453/753
33
15
210
203
Ø120
Wall
Cupboard
Door
For top ducting cut hole to suit size
Drill 6 mm holes
Fig.8 Mounting to
underside of cabinetry
Fig.4 Preparing for install
70
Fig.7 Panel heights
Cooking fumes
Filtered air
Fig.5 Spacer Lateral
Screw shall be fixed into
lower face of the hood
Fig.6 Spacer Rear