Filter
Top Products
21
D
B
PE
A
N
L
Feeder cable section
“TYPE H05RR-F”
230V 3 x 2.5 mm
2
(**)
(**) - Connection with wall
box connection.
Power Supply
230V - 50Hz 4500W 19,5A (230V)
Connecting the feeder cable
To connect the feeder cable to the cooker:
Remove the screws securing the
cover “A” on the rear of the cooker.
Feed the supply cable through the
cable clamp “D”. See the ‘Feeder cable
section’ following for the correct size for the
cable.
Connect the wires to the terminal
block “B” as shown in the diagram; or
connect the phase wires to the terminal
block “B” and the earth wire to the terminal
PE as shown.
Take up any slack in the cable and
secure with the cable clamp “D”.
Replace the cover “A”.
N.B. The earth conductor must be left
about 3 cm longer than the others.
Figure 16a Connecting the feeder cable
Installation instructions
230 V
PEN
L
1
(L2)
PE Earth
N Neutral
L Live
PE Earth
N Neutral
L Live
Figure 16b Connecting the feeder cable