Filter
Top Products
CLEANING AND MAINTENANCE OF YOUR APPLIANCE
Never immerse the appliance in water or any other liquid.
Always turn the appliance off and unplug it before cleaning.
Daily maintenance
Fill the Water Reservoir or empty the Drip Tray if required. Any
other daily maintenance should be unnecessary.
Weekly maintenance
Wipe the outside of the appliance with a damp cloth.
Open the Pack Door and wipe the inside surfaces of the Pack
Holder with a damp cloth.
The Pack Door, Drip Tray and Cup Stand should be washed with a
wet cloth.
Do not clean with brushes or scouring agents as this may
damage the surface of your appliance.
Do not wash with excessive amounts of water, it could get into
the machine causing a malfunction.
Do not use cleaning agents as they may leave a residue on the
appliance.
Do not apply any products containing benzene, they may
damage the surface of your appliance.
How to remove the Pack Door
Open the Pack Door as described in section 4 BREWING YOUR
BEVERAGES.
Pull the Pack Door straight down to remove.
The Pack Door should only be removed in the open position.
To re-fit the Pack Door, push straight up until you feel a “click.”
The Pack Door should only be re-fitted in the open position.
Do not attempt to operate the appliance without the Pack Door
fitted.
13
PREPARING YOUR APPLIANCE FOR USE
YOU CANNOT BREW BEVERAGES IF YOU HAVE NOT PRIMED THE
APPLIANCE FIRST!
The priming cycle fills the boiler with water.After this your appliance
will be ready to use.
Remove the Water Reservoir from the machine.
Remove the Lid. Inside you will find a Water Filter. Remove the
Filter from its packaging and install, small end first, by pushing it
firmly into the round location at the bottom of the Water
Reservoir.
Fill the Water Reservoir with cold water up to the MAX indication
line and put it back on to the appliance. Replace the Lid.
Put the Plug into a 120V AC electrical outlet.
Put the Drip Tray onto the appliance in the position indicated.
Ensure the Pack Door is closed and the Brew Head is in the down
position.
DO NOT fit the Cup Stand at this stage.
6
J1 User Guide 21/6/05 1:16 pm Page 13