13
ENGLISH
Technical Data
Category II 2H3+ appliance
G20 Small 72 1000 400 95 l/h
naturalgas Medium 97 1750 440 167 l/h
(methane) Fast 115 3000 800 286 l/h
20 mbar Triple-ring 140 3300 1600 314 l/h
G30-G31 Small 50 1000 400 73 g/h
liquefied gas
Medium 65 1750 440 127 g/h
Fast 85 3000 800 218 g/h
30/37 mbar Triple-ring 91 3300 1600 240 g/h
TYPE OF GAS BURNER
INJECTOR
MARKING
RATED THERMAL
CAPACITY
IN WATTS
REDUCED THER-
MAL CAPACITY
IN WATTS
RATED
CONSUMPTION
Overall thermal capacity: see the identification plate on the bottom of the cooktop.
Combustion supporting air: 2 m
3
/h per kW of installed power - see identification plate.
Supply voltage: 220/230 V 50 Hz
Installation
Installation and connection to the mains should be carried out in compliance with
national laws in force.
The following paragraphs describe installation procedures both for the gas and for the
electrical sections. These tasks must be performed according to current standards and
by qualified personnel: performance by inexpert persons can create dangers. The manu-
facturer declines all responsibility for harm to persons or property caused by failure to
comply with these requirements.
Important
- The appliance must be installed by expert and qualified personnel according to current
standards.
- Turn to a Franke Service Centre for all repairs and maintenance.
- Never use deformed or unstable pots and pans on the burners which could overflow or
tip over.
- If the appliance has a cover make sure the burners are cool before closing the cover.
- Close the gas supply valve when the hob is not being used.
The manufacturer accepts no responsibility for injury to persons or damage to property
caused by failure to comply with this procedure. This appliance can only be used for
cooking. Any tampering with or modification to the appliance can be a source of danger.
Make sure gas distribution systems are as required before installing the appliance. The
gasfor which the hob is designed is indicated on the label on the bottom of the control
box. This appliance is not joined to a device for evacuating products of combustion and
must be installed and hooked-up according to current regulations.
_1913_P RIBAS ML (0384611) 19-06-2003 16:59 Pagina 13
PREVIOUS DOCUMENT