Franke Consumer Products FDF 9044 I Cooktop User Manual


 
EN
2
0
20
Recirculation version air outlet
Fix the connection 15 to the frame using the 4 screws pro-
vided.
Fix the flange 10 to the lower opening of the connection 15.
Connect the hood air outlet to the flange in the lower part of
the junction using a rigid or flexible ø 150 tube (by installer’s
choice).
15
10
Flue assembly - Mounting the hood body
Position the upper chimney section and fix the upper part to the
frame using the 2 screws 12c (2,9 x 6,5) provided.
Similarly, position the lower chimney section and fix the
lower part to the frame using the 2 screws 12c (2,9 x 6,5) pro-
vided.
Before fixing the hood body to the frame:
Remove the grease filters from the hood body.
Remove any activated charcoal filters.
From below, use the 4 screws 12f (M6 x 10)provided to fix the
hood body to the frame.
12f
12c
12c
ELECTRICAL CONNECTION
Connect the hood to the mains through a two-pole switch hav-
ing a contact gap of at least 3 mm.
Remove the grease filters (see paragraph Maintenance) being
sure that the connector of the feeding cable is correctly inserted
in the socket placed on the side of the fan.
Connect the control connector Cmd.
Place the connectors in the junction box 24 and close it using
the 2 screws 12e (2,9 x 9,5) provided.
Fix the junction box to the hood body using the 2 screws 12c
(2,9 x 6,5) provided.
For the recirculation version, fit the activated carbon odour fil-
ter.
Replace the grease filters.
24
12e
Cmd
12c