Filter
Top Products
5
1. Load dishwasher (See Preparing and Loading
Dishes).
2. Add detergent (See Dishwasher Dispenser &
Detergents).
3. Add rinse aid (See Rinse Aid).
4. Select desired CYCLE (See Cycle Chart). The
indicator light above the pad will glow when selected.
5. Select desired OPTIONS (See Energy Options). The
indicator light above the pad will glow when selected.
6. Run hot water faucet nearest dishwasher until water
is hot. Turn water off.
7. To start, press START/CANCEL pad.
8. Close door to latch.
NOTE
The dishwasher is programmed to remember your last cycle
so you do not have to reset each time. To start the dishwasher
using the same cycle and options selected on the previous
wash, just press the START/CANCEL pad.
Wash Cycle Selections
Cycle times are approximate and will vary with options
selected. Hot water is necessary to activate dishwasher
detergent and melt fatty food soils. An automatic sensor
will check the incoming water temperature and, if it is
not hot enough, the timer will be delayed for automatic
water heating in the main wash of all cycles. This
happens even when HI-TEMP WASH option has not been
selected. When HI-TEMP WASH is selected, an even
higher temperature will be guaranteed to handle heavier
soil loads.
OPERATING INSTRUCTIONS
Options Selections
Wash Pressure
The WASH PRESSURE option allows you to select the
desired wash pressure depending on your dishload. When
HIGH WASH PRESSURE is selected, the wash pressure is
increased by 30% to provide faster and more effective
cleaning. When LOW WASH PRESSURE is selected, the
wash pressure is decreased by 30% to clean delicate dishes
without damage. HIGH WASH PRESSURE can be used with
all cycles except CHINA CRYSTAL and RINSE ONLY. HIGH
WASH PRESSURE is automatically provided when POWER
PLUS or QUICK CLEAN cycles are selected. LOW WASH
PRESSURE can be used with all cycles except QUICK CLEAN
and RINSE ONLY. LOW WASH PRESSURE is automatically
provided when CHINA CRYSTAL (TOP RACK) is selected.
WASH PRESSURE may be selected before the wash cycle is
started, or anytime during the wash cycle.
Getting Started
Hi-Temp Wash
When HI-TEMP WASH option is selected, the dishwasher
heats water in the main wash to approximately 140°F
(60°C).
This increase in water temperature helps
dishwasher detergent remove food grease and soil from
dishes more effectively and aids in drying. This option is
available in NORMAL WASH and TOP RACK. HI-TEMP WASH
is automatically provided when POWER PLUS cycle is
selected.
Press the CIRCLE to activate
drying
washing
delay
clean
s
my
favorite
power
plus
quick
clean
normal
wash
energy
saver
rinse
only
wash
pressure
wash
temp
dry
power plus
delay
start
START
cancel
top
rack
1-24 hrs
heavy
medium
lite
sanitize
hi temp
nor mal
hea t
air
add rinse aid
hold to lock
hold 3s