Frigidaire 154768701 Dishwasher User Manual


 
16
Food Soils Left on Dishes
Choose another cycle for longer washing time.
Check rack loading section for proper loading—avoid
nesting items.
Home water pressure may be too low—should be 20
to 120 pounds per square inch (psi).
Check incoming water temperature. It should be at
least 120°F (49°C). (See Factors Affecting
Performance.)
Check water hardness. For extremely hard water, it
may be necessary to install a water softener. (See
Detergent Chart.)
Use fresh detergent.
Check to make sure funnel in top rack is not blocked.
Make sure items are not blocking the spray arms,
preventing them from rotating.
SOLUTIONS TO COMMON DISHWASHING PROBLEMS
Dishware Stained or Discolored
Tea and coffee can stain cups. Remove the stains by
hand washing in a solution of 1/2 cup (120 ml) bleach
and one quart (1 L) of warm water. Rinse thoroughly.
Iron deposits in water can cause a yellow or brown film.
A special filter installed in the water supply line will
correct this problem. (See Removing Spots and Film.)
Aluminum utensils can leave gray/black marks when they
rub against other items. Load properly.
Certain high acid foods can cause discoloration of
stainless steel and plastics if allowed to sit for a long
period. Use the Rinse & Hold cycle or rinse by hand if
not operating dishwasher at once.
Mixing stainless steel and silver utensils in silverware
basket can cause pitting of the stainless steel blades.
Avoid mixing stainless steel and silver.
Glassware/Flatware Spotted or
Cloudy
Check water hardness. For extremely hard water, it may
be necessary to install a water softener. (See Detergent
Chart.)
Water temperature may be low. Avoid extremely low or
high temperatures. (See Factors Affecting Performance.)
Avoid overloading and improper loading. (See Preparing
and Loading Dishes.)
Use fresh detergent. Old detergent is ineffective.
Make sure rinse aid dispenser is filled.
Check to see that proper amount of detergent is being
used for cycle selected. Also, check phosphate level.
(See Detergent Dispenser.)
Home water pressure may be too low—it should be 20 to
120 pounds per square inch (psi).
Dishes not Dry
Select heat dry option.
Make sure the rinse aid dispenser is filled.
Increase the amount of rinse aid. (See Rinse Aid.)
Check the incoming water temperature. Be sure it is at
least 120°F (49°C).
Check for proper loading—avoid nesting items.
Plastic items may need to be towel dried.
Cups with a concave bottom will collect water.
Before calling for service, review this list.
It may save you both time and expense.
This list includes common experiences
that are not the result of defective
workmanship or material in your
dishwasher.