Filter
Top Products
4
DISHWASHER FEATURES
Getting Started
1. Load dishwasher
2. Add detergent
3. Add rinse aid
4. Select desired CYCLE. The indicator light above the
pad will glow when selected.
5. Select desired OPTIONS. The indicator light above
the pad will glow when selected.
6. Run hot water faucet nearest dishwasher until water
is hot. Turn water off.
NOTE
The dishwasher is programmed to remember your last
cycle so you do not have to reset each time. To start the
dishwasher using the same cycle and options selected on
the previous wash, just press the START/CANCEL pad.
Heating Element
Glass Trap
Rinse Aid
Dispenser
Nozzle and Upper Spray Arm
Tub Gasket
Middle Spray Arm
Lower Spray Arm
Detergent Dispenser
Vent
Top Rack
Serial Label
(located on right
side of tub)
Bottom Rack
Your dishwasher cleans by spraying a mixture of hot water and detergent through the spray arms against soiled surfaces.
Each cycle begins with a pre-drain. Next, the dishwasher fills with water covering the filter area. Water is then pumped
through the spray arms. Soil particles go down the drain as the water is pumped out and replaced with clean water. The
number of water fills will vary with the cycle being used. Features may vary by Model.
Silverware
Basket
Cup Shelves
Overfill Protector
Bowl Tines
7. To start, press START/CANCEL pad.
8. Close door to latch.