Frigidaire 18 inch built in and portable Dishwasher User Manual


 
8
Factors Affecting Performance
Water Pressure
Water pressure should be between 20 and 120
pounds per square inch. Low water pressure
occurs most often during periods of high water
consumption, such as when laundry or showers
are being done. To determine if you have enough
water pressure, put a 2 quart container under fully
opened hot water faucet nearest the dishwasher. It
should fill in less than 14 seconds. Be sure all
other faucets are turned off during test.
Rinse Aid
Rinse aid greatly improves drying and reduces
water spots and filming. Water “sheets” off
dishes rather than forming water droplets that cling
and leave spots.
A dispenser, located next to the detergent cup,
automatically releases a measured amount of
rinse aid during the last rinse. If spotting and poor
drying are problems, increase the amount of rinse
aid dispensed by rotating the dial to a higher
number. The dial is located under the dispenser
cap. The indicator will be dark when full and will
show clear when it is time to refill.
To add liquid rinse aid, turn dispenser cap 1/4 turn
counterclockwise and lift out. Pour in rinse aid until
liquid touches the indicated fill level. Replace cap.
Do not overfill since this can cause oversudsing.
Wipe up any spills with a damp cloth.
The dispenser holds enough for 35 to 140 washes,
depending on setting.
Adjustable
setting
Dispenser Opening
Dispenser Cap
Indicator
Water Temperature
Hot water is needed for best dishwashing and
drying results. Water entering dishwasher should
be at least 120°F (49°C) to give satisfactory
results.
To check water temperature entering dishwasher:
Turn on hot water faucet nearest dishwasher for
several minutes to clear cool water from pipes.
Hold a candy or meat thermometer in stream of
water to check the temperature.
If temperature is below 120°F (49°C), have a
qualified person raise the hot water heater
thermostat setting.
Important: Before starting a cycle, run hot
water to clear cool water from pipe.