Frigidaire 242046800 Refrigerator User Manual


 
6

NOTE
DO NOT remove center screw from freezer drawer.
This is a factory adjustment.

:
Slightly open freezer drawer. Lift the toe grille and
gently pull forward (see illustration).
 


• Allfourcornersofthecabinetmustrestrmlyon
theoor.
• Thesidesshouldtilt
1
/
4
inch (6 mm) from front to
back (to ensure that doors close and seal properly).
• Doorsshouldalignwitheachotherandbelevel.



 You can raise or lower each door. use a 3/8 inch
socket wrench to turn the adjustment screws (1
per side).
: turn adjustment screw clockwise.
: turn adjustment screw counterclockwise.
2 Ensure both doors are bind-free with their seals
touching the cabinet on all four sides and that
cabinet is stable.
3 After unit is leveled, lower anti-tip leg until it
contactstheoor.
2 Check gasket seal around top, bottom, and sides of
freezer drawer.
3 If gasket is not sealed, open drawer and slightly
loosen four (4) drawer screws (two (2) on each
side) to allow drawer to rotate.
4 Close drawer and recheck the seal on the gasket
(A). Open the drawer grabbing by the sides in the
center (B). Be careful not to rotate the drawer.
Tighten four (4) drawer screws.
Recheck gasket seal.
7 Installthetoegrillebyttingintoplace.
Pull Drawer Out
From Both Sides
Grab Drawer
At Center
Then
Push Against
Freezer Drawer
A B
Raise
Lower
Anti-tip
Leg
Door
Door