Filter
Top Products
IMPORTANT
Your ice maker is shipped with the wire signal arm in
the ON position. To ensure proper function of your
ice maker, hook up water supply immediately or turn
ice maker OFF by lifting the wire signal arm until it
clicks and locks in the UP position.
Check the leveling bracket on the ice maker to ensure
the ice maker is level. If the gap between the freezer
wall and the ice maker is the same at top and bottom,
then ice maker is level. If the ice maker is not level,
loosen the screw and slide the bracket to the correct
position to make it level. Retighten the screw. You
will need a 1/4 inch socket wrench for this task.
14
14
14
14
Ice Service
Ice
Container
1” or less
Leveling Bracket
CAUTION
• DO NOT place the ice container in dishwasher.
• Wash the ice container in warm water with mild
detergent. Rinse well and dry.
• Stop the ice maker when cleaning the freezer
and during vacations.
INTERIOR LIGHTING
The mid level and upper level lighting comes on
automatically when the door is opened.
To replace the light bulbs:
1. To replace the light bulb, turn the temperature
control to OFF and unplug the electrical cord.
2. Remove the lens from the lamp housing by
unsnapping it from the lamp housing using your
fi ngers or a screwdriver. Be careful not to break the
locking tabs on the lamp housing.
3. Replace the old bulb with a bulb of the same type
and wattage.
4. To replace the lens, snap one side of the lens
opening to the tab on the lamp housing. Then
carefully attach the other side.
IMPORTANT
To disconnect power to the unit, unplug the unit or
switch the breaker that supplies power to the unit to
the off position. Replace the old bulb with a bulb of
the same wattage.
Mid Level Lighting Light Bulb Removal