Filter
Top Products
8
Status Indicator Lights
Operating Instructions (continued)
The CLEAN light will come on at end of cycle and
remain on until door is opened.
When the SANITIZE option is selected, the
SANITIZED light will glow when the SANITIZE
cycle is finished. If the dishwasher did not properly
sanitize the dishes, the light will not come on. This
can happen if the cycle is interrupted. The light will
remain on until the door is opened.
The WASHING light comes on at the beginning of
cycle and remains on until the end of the main
wash.
The SENSING light comes on at the beginning of
the cycles that incorporate the smart sensor and
will remain on until the end of the sensing
sequence.
1H-24H……….. Number of delay start hours.
The last hour will count down in
minutes.
CL……………… Close dishwasher door. The
status indicator lights will also
flash to indicate current cycle
status.
HO…………..… Flashes to indicate a water heat
delay.
MINUTES…...… Number of minutes left in cycle
(1-99). If cycle is longer than 99
minutes, a small light will appear
in the lower right corner and
remain on until time counts below
99.
PF……………… Appears in window when
dishwasher is first installed, or
when power has been
interrupted. HI-TEMP WASH
and NO HEAT DRY indicator
lights will also flash. To clear,
touch START/CANCEL pad.
The RINSING AGENT LOW light comes
on at the end of a cleaning cycle when the rinse
agent reservoir is low. The light will remain on
through 5 successive cycles or until the reservoir
is filled.
The DRYING light indicates the drying portion of
the cycle. The light will come on when either drying
option is selected.
Note: The time remaining could suddenly increase
or drop several minutes. This means the Smart
Sensor has checked the soil level and determined
if additional water fills are needed or if water fills
can be deleted.