Frigidaire 316000653 Range User Manual


 
6
Setting the Clock and
Minute Timer
(if equipped)
Figure 2 Only
To Set the Clock (Figure 2 Only)
When the range is first plugged in, or when the power supply to the range has
been interrupted, the display will flash "12:00".
1. Push .
2. Within 5 seconds, push and hold or until the correct time of day
appears in the display.
Note: The clock cannot be changed during any timed bake or self-clean
cycle.
To Set the Minute Timer
1. Push .
2. Push to increase the time in one minute increments. Push and hold
to increase the time in 10 minute increments. The timer can be set for
any amount of time from 1 minute to 11 hours and 59 minutes.
Note: If you push first, the timer will advance to 11 hours and 59
minutes.
3. The display shows the timer count down in minutes until one minute
remains. Then the display will count down in seconds.
4. When the set time has run out, the timer will beep 3 times. It will then
continue to beep 3 times every 60 seconds until is pushed.
Note: The minute timer does not start or stop cooking. It serves as an extra
timer in the kitchen that will beep when the set time has run out. The minute
timer can be used alone or during any of the other oven functions. When the
minute timer is in use with any other mode, the minute timer will be shown in
the display. To view other functions, push the function pad for that mode.
To Change the Minute Timer while it is in use:
While the timer is active and shows in the display, push and hold or
to increase or decrease the time.
To Cancel the Minute Timer before the set time has run out:
Push .
For a silent control panel
(Figure 2 Only):
When choosing a function, a beep
will be heard each time a pad is
pushed. If desired, the controls can
be programmed for silent operation.
Push and hold STOP TIME. After 7
seconds, the control will beep once.
This will block the controls from
sounding when a pad is pushed. To
return the sound, push and hold
STOP TIME again for 7 seconds until
1 beep is heard. Note: The control
will return to the audible mode after
a power outage.