Filter
Top Products
9
Setting Surface Controls
ESEC Hot Element Indicator Message (HE)
After using any of the single, dual or Bridge radiant element positions the
cooktop will become very hot. Even after turning the control knob to OFF, the
cooktop will remain hot for some time. The ESEC control monitors the
temperature of the cooktop and displays the message “HE” (hot element)
warning when the cooktop is still too hot to touch (See Fig.1). If the HE message
appears in the window, the control can still be turned on again for use.
ESEC Error Indicator Message (Er)
An error message will be displayed (flashing “Er”) at power up (or after a power
failure) if ANY of the surface control knobs were left in the ON positions. If a
power failure should occur, be sure to set all of the 4 surface control knobs to the
OFF position (See Fig. 2). This will reset the surface controls.
Some models have single radiant surface elements at 2 locations; the right rear (Fig. 6) and
left rear (Fig. 7) element positions. The BRIDGE (some models) element position can also be
used as a single element (See Bridge Element Operating Instructions on pages 10-11).
1. Place correctly sized cookware on the radiant surface element.
2. Push in and turn the surface control knob in either direction to the desired setting using
the ESEC digital display window for the desired setting (Fig. 4). Turn (do not push) the
knob to adjust the setting if desired. Start most cooking operations on a higher setting
and then turn to a lower setting to finish cooking. Each surface element provides a
constant amount of heat at each setting. A glowing red surface heating area extending
beyond the bottom edge of the cookware indicates the cookware is too small for the
surface heating area.
3. When cooking has completed, turn the surface control knob to OFF before removing the
cookware. Note: The HE message will appear after turning the control knob to OFF if the
cooktop is still hot and will remain on until the heating surface area has cooled
sufficiently.
Note: See page 8, Fig. 5 for recommended control settings.
To Operate the Single Elements (some models):
ESEC Lockout Feature ( - - )
The Self-Clean feature will not operate whenever a radiant surface element is ON. Conversely the
ESEC feature will not operate during the Self-Clean cycle. Whenever the ESEC Lockout feature is
active, “ - - ” may appear in any display window (See Fig. 3). If any of the surface elements are still
hot during active Lockout, “HE” will appear in the window instead of the “- -” message.
Radiant surface elements may appear to have cooled after they have been turned off. The glass surface
may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.
The Single Radiant Elements (some models)
Fig. 6
Right Rear Element (some models).
Fig. 7
Left Rear Element (some models).
Fig. 1
Fig. 3
Fig. 4