Filter
Top Products
5
ELECTRIC COOKTOP INSTALLATION INSTRUCTIONS
Cooktop Installation
1. All Ceramic-Glass Cooktops
Visually inspect the cooktop for damage. Also make
sure all cooktop screws are tight (see Figure 8).
Set the cooktop into the countertop cutout.
NOTE: Do not use caulking compound; cooktop
should be removable for service when needed.
Do not remove the nylon spacers on
the edges of the cooktop. These spacers center the
cooktop in the space provided. The cooktop must
be centered to prevent excess heat buildup that
may result in heat damage or fire (see Figure 9).
Figure 10
COOKTOP
Retainer Brackets Must
Be Installed At Least
1/16" (0.16 cm) BELOW
Countertop
NYLON
SPACER
COUNTERTOP
RETAINER
BRACKET
SCREWS
Figure 8
2. Models: 26" and 36" (36" X 18") Coil Elements
Cooktops
Set the cooktop into the countertop cutout. Lift the
cooktop and fasten the ends of the box to the counter
with wood screws (figure 11). Lower the cooktop.
Align the knobs on the shafts and press down with
even pressure.
WARNING
Figure 9
6 NYLON SPACERS
2 RETAINER
BRACKETS
POSITION BRACKETS
ON UNIT CUTOUT
CENTER LINE
The retainer brackets MUST be installed, to meet
local codes or, in their absence, with the National
Electrical Code ANSI/NFPA No. 70—latest edition,
or with CSA Standard C22.1, Canadian Electrical
Code, Part 1 (see Figure 10).
3. Models: 32" Coil Elements Cooktops
1. Place cooktop into countertop opening and
center unit in cutout.
2. Remove all surface units and drip bowls.
3. Unit clamp down information. Once unit is
installed in counter opening, you must clamp unit
down as shown in figure 12.
4. Put back all surface units and drip bowls.
5. Make electrical connections as outlined in
"Electrical Connection" section.
Figure 11
COOKTOP
COUNTERTOP
SCREW
BURNER BOX