Filter
Top Products
8
Fig. 5 Fig. 6
SETTING SURFACE CONTROLS
Operating the Dual Surface Radiant
Element
The cooktop is equipped with a dual radiant surface
element located at the right rear (See Figures 1 & 2)
position. Symbols around the knob are used to indicate
which coil of the dual radiant element will heat. The
symbol indicates that only the inner coil will heat (Fig. 5).
The symbol indicates that both inner and outer coils
will heat (Fig. 6). You may switch from either coil setting
at any time during cooking.
To Operate the Dual Surface Element
1. Place correctly sized cookware on the dual surface
element.
2. Push in and turn the control knob as shown in Figure 3
for smaller cookware or in Figure 4 for larger cookware.
3. Turn the knob to adjust the setting if needed. Start
most cooking operations on a higher setting and then
turn to a lower setting to nish cooking. Each surface
element provides a constant amount of heat at each
setting. A glowing red surface heating area extending
beyond the bottom edge of the cookware indicates the
cookware is too small for the surface heating area.
4. When cooking has completed, turn the surface
control knob to OFF before removing the
cookware.
Figure 1
Figure 2
Figure 3 Figure 4
Control knobs shown are typical only.
NOTE
See Recommended Setting for Surface Element table on
page 6.
CAUTION
Radiant surface elements may appear to have cooled
after they have been turned OFF. HE (Hot Element)
message will turn ON and will continue to glow until the
glass cooktop has cooled down to a moderate level. The
glass surface may still be hot and burns may occur if
the glass surface is touched before the indicator light has
turned OFF. The message may remain on even though
the controls are turned OFF.
CAUTION
Do not place plastic items such as salt and pepper
shakers, spoon holders or plastic wrappings on
cooktop when it is in use. These items could melt or
ignite. Potholders, towels or wooden spoons could catch
re if placed too close to the surface elements.
CAUTION
Do not allow aluminum foil, or ANY material that
can melt to make contact with the ceramic glass
cooktop. If these items melt on the cooktop they will
damage the ceramic cooktop.
NOTE
The surface “Element On” indicator lights will glow
when one or more elements are turned on. A quick
glance at these indicator lights when cooking is nished
is an easy check to be sure all surface elements are
turned off.