Filter
Top Products
18
To Remove and Replace Warm & Serve Drawer (some models)
To remove Warm & Serve Drawer:
1. Turn power off before removing the
Warm & Serve drawer.
2. Open the drawer to the fully opened position.
3. Locate the latches on both sides of the
Warm & Serve drawer.
4. Pull up on the left glide latch and push down on the right glide latch.
5. Pull the drawer away from the range.
6. To clean Warm & Serve drawer, gently scour with a soapy scouring pad,
this will remove most spots. Rinse with a 1:1 solution of clear water and
ammonia. If necessary, cover difficult spots with an ammonia-soaked
paper towel for 30 to 40 minutes. Rinse with clean water and a damp cloth.
Remove all cleaners or the porcelain may become damaged during future
heating. DO NOT use spray oven cleaners on the cooktop.
To Replace Warm & Serve Drawer:
1. Align the glide latches on both sides of the drawer with the slots on the drawer.
2. Push the drawer back into the range.
Electrical Shock Hazard can occur and result
in serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the Warm & Serve drawer.
Front
Frame
Roller
Guide
Roller
Storage
Drawer
To Remove and Replace Storage Drawer (some models)
Use the storage drawer for storing cooking utensils. The drawer can be removed to facilitate cleaning under the range. Use
care when handling the drawer.
Removing and Replacing Storage Drawer
To remove the drawer:
1. Pull empty drawer out to the roller guide stop.
2. Tilt the drawer up and pull it out over the rollers.
To replace the drawer:
1. Insert the rear end of the drawer into the opening.
2. Fit the drawer end rollers onto the guide rails.
3. Push the drawer in until it stops, then lift to allow the rollers to clear the roller
guide stop, and push in.
Care & Cleaning
Latch
Latch
Left Glide
Right Glide
Pull up latch
with finger
Pull down latch
with finger
Figure 1