Filter
Top Products
18
Care & Cleaning
Electrical Shock Hazard can occur and result in
serious injury or death. Disconnect appliance from electric power
before cleaning and servicing the warm & Serve drawer.
Removing and Replacing Warm & Serve Drawer
To Remove Warm & Serve Drawer:
1. Turn power off before removing the warm & Serve drawer.
2. Open the drawer to the fully opened position.
3. Locate glide lever on each side of drawer, pull up on the left glide lever and
push down on the right glide lever (See Figure 1).
4. Pull the drawer away from the range.
To Replace Warm & Serve Drawer:
1. Pull the bearing glides to the front of the chassis glide (See Figure 2).
2. Align the glide on each side of the drawer with the glide slots on the range.
3. Push the drawer into the range until levers “click” (approximately 2”). Pull the
drawer open again to seat bearing glides into position. If you do not hear the
levers “click” or the bearing glides do not feel seated remove the drawer
and repeat steps 1 thru 3. This will minimize possible damage to the bearing
glides.
NOTE: The Warm & Serve Drawer will NOT operate while in the “Self-Clean” and
“Oven Lockout” modes
Bearing Glide
Figure 2
Figure 1
Latch
Latch
Left Glide
Right Glide
Pull up latch
with finger
Pull down latch
with finger