Frigidaire 4000 Dishwasher User Manual


 
19
Solutions to Common Dishwashing Problems
(continued)
Dishwasher Does Not Drain
Properly
If unit is hooked up to a food waste disposer,
make sure the disposer is empty.
Check to see if the knockout plug has been
removed from inside the food waste
disposer inlet.
Check to see if drain hose is kinked.
Make sure cycle is complete, not in a pause.
Cycle Takes a Long Time
Is cycle in a water heating delay?
Has the delay start option been selected?
Has the sanitize option been selected?
Dishwasher Won’t Fill
Is water supply turned on?
Does overfill protector move up and down
freely? (See Overfill Protector section.)
Dishwasher Has an Odor
Soiled dishes left in dishwasher too long
can create an odor. Use Rinse Only cycle.
There will be a “new” smell when first
installed. This is normal.
Check to see if unit is draining properly.
(See Dishwasher Does Not Drain Properly.)
Stains on Tub Interior
Washing large amounts of dishware with
tomato based soil can cause a pink/orange
appearance. This will not affect performance
and will gradually fade over time. Pre-
rinsing or using the Rinse Only cycle will
reduce the chance of staining. Using no
heat dry option will lessen staining.
Removing Spots and Film
Hard water can cause lime deposit buildup on
the interior of the dishwasher. Dishes and
glasses may also get spots and film for a
number of reasons. (See Glassware/Flatware
Spotted or Cloudy section.) To remove buildup,
spots and film, clean using the following
instructions:
1. Load clean dishes and glasses in normal
manner. Do not load any metal utensils or
silverware.
2. Do not add detergent.
3. Select the NORMAL WASH cycle. Close
and latch door. Press START/CANCEL
pad.
4. Allow dishwasher to run until it starts the
second water fill (approximately 10
minutes).
5. Unlatch and open door and pour 2 cups of
white vinegar into the bottom of
dishwasher.
6. Close and latch door and allow cycle to
finish.
Note: If these conditions persist, a home water
softener should be considered.