8
Status Indicator Lights
Operating Instructions (continued)
The CLEAN light will come on at end of cycle and
remain on until door is opened.
When the SANITIZE option is selected, the
SANITIZED light will glow when the SANITIZE cycle
is finished and remain on until the door is opened.
If the dishwasher did not properly sanitize the
dishes, the light will not come on. This can happen
if the cycle is interrupted or if incoming water
temperture is below 120
o
F.
The WASHING light comes on at the beginning of
cycle and remains on until the end of the main
wash.
PF……………… Appears in window when
dishwasher is first installed, or
when power has been
interrupted. HI-TEMP WASH
and NO HEAT DRY indicator
lights will also flash. To clear,
touch START/CANCEL pad.
1H-24H……….. Number of delay start hours.
The last hour will count down in
minutes.
CL……………… Close dishwasher door. The
status indicator lights will also
flash to indicate current cycle
status.
HO or Hd…..… Indicate a water heat delay.
MINUTES…...… Number of minutes left in cycle
(1-99). If cycle is longer than 99
minutes, a small plus sign will
appear beside the number of
minutes and remain on until
time counts below 99.
The RINSING AGENT LOW light, Located
near the Rinse Only Pad, comes on at the end of a
cleaning cycle when the rinse agent reservoir is
low. The light will remain on through 5 successive
cycles or until the reservoir is filled.
The DRYING light indicates the drying portion of
the cycle. The light will come on when either drying
option is selected.
Note: The time remaining could suddenly increase
or drop several minutes. This means the iSense
Soil Sensor has checked the soil level and
determined if additional water fills are needed or if
water fills can be deleted.
In the unlikely event the dishwasher malfunctions,
the indicator may display one of the following
codes "Er", "uF", "uo", or "CE". If one of these
codes are displayed contact the Frigidaire
Customer Care Center at
1-800-944-9044
They will be able to provide assistance in
troubleshooting the problem and/or locating an
authorized service technician, if needed.