Filter
Top Products
7
Before Setting Oven Controls
Oven Vent Location (Coil Cooktop models only)
For models equipped with coil surface elements, the oven vent is located under
the left rear surface element. When the oven is on, warm air flows through the
left rear element. This venting is necessary for proper air circulation in the oven
and good baking results. DO NOT BLOCK THE OVEN VENT.
Oven Vent Location (Ceramic Cooktop models only)
For models equipped with ceramic glass cooktops, the oven vent is located
under the left rear side of the control panel. When the oven is on, warm air
is released through the vent. This venting is necessary for proper air circulation
in the oven and good baking results. DO NOT BLOCK OVEN VENT.
Arranging Oven Racks
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING THE OVEN). Always use oven
mitts when using the oven.
Removing & Replacing Oven Racks
To remove, pull the rack forward until it stops. Lift up front of rack and slide out. To replace, fit the rack onto the guides on
the oven walls. Tilt the front of the rack upward and slide the rack back into place.
Element On and Hot Surface Indicator Lights
The Coil Cook Top range is equipped with a surface control light that will glow on your range—
the Element On indicator light.
The Ceramic Glass Cooktop range is equipped with two different surface control lights that
will glow on your range— the Element On indicator light and a Hot Surface indicator light.
The Element On (all models) located on the control panel, will glow when any surface element
is turned on. A quick glance at this light after cooking is an easy check to be sure all surface
controls are turned off.
The Hot Surface (Ceramic Glass Cooktop models only) indicator light, located on the
control panel, will glow as the surface cooking area heats up and will REMAIN ON until the
glass cooktop has cooled to a MODERATE level.