Filter
Top Products
19
E
CLEANING AND CARE
CHARCOAL FILTER
Charcoal Filter, which was enclosed with your microwave oven, is
used for nonvented, recirculated installation. The fi lter should be
changed every 6 to 12 months depending on use.
1. Disconnect power to the microwave oven at the circuit breaker
panel or by unplugging.
2. Remove the louver mounting screws.
3. Pull the louver away from the unit.
4. Change the charcoal fi lter.
5. Carefully push the louver back into place and replace the screws
removed in step 2.
MICROWAVE OVEN LIGHT
Remove the louver per instructions 1-3 above and charcoal fi lter,
if used.
1. To replace light bulb, fi rst disconnect power to the microwave
oven at the circuit breaker panel or by unplugging.
2. Open light cover located behind fi lter mounting by carefully pulling
up on the front edge.
3. Remove old light bulb and replace only with equivalent watt
bulb available from parts distributor. Bulbs are also available at
most hardware stores or lighting centers. DO NOT USE BULB
LARGER THAN 30 WATTS.
4. Replace the microwave oven light cover by carefully pushing into
place. Replace the charcoal fi lter, if used. Push the louver back
into place (engaging both the bottom and top tabs) and replace
the louver mounting screw.
WORK LIGHT AND NIGHT LIGHT
1. To replace light bulbs, fi rst disconnect power to the microwave
oven at the circuit breaker panel or by unplugging.
2. To release cover, remove the screw on the light cover. (See
illustration.)
3. Replace light bulbs with equivalent watt bulb available from
parts distributor. Bulbs are also available at most hardware
stores or lighting centers. DO NOT USE A BULB LARGER
THAN 30 WATTS.
4. Close light cover and secure with screw removed in step 2.
Light cover may become very hot. Do not touch
glass when light is on.
Oven light
Hood louver
Charcoal fi lter
Bottom tab
Light cover
Screw
Light bulbs