Filter
Top Products
4
Important Safety Instructions
UNPACKING AND EXAMINING YOUR MICROWAVE OVEN
Remove:
• All packing materials from inside the microwave oven cavity; however, DO NOT
REMOVE THE WAVEGUIDE COVER, which is located on the right cavity wall. Read
enclosures and SAVE the Use and Care Manual.
• The feature sticker, if there is one, from the outside of the door.
Check the microwave oven for any damage, such as misaligned or bent door,
damaged door seals and sealing surfaces, broken or loose door hinges and latches
and dents inside the cavity or on the door. If there is any damage, do not operate the
microwave oven and contact your dealer or ELECTROLUX AUTHORIZED
SERVICER.
CHOOSING A LOCATION FOR YOUR MICROWAVE OVEN ON
THE COUNTER
You will use the microwave oven frequently so plan its location for ease of use. It’s wise, if possible, to have counter space on at least one
side of the microwave oven. Allow at least 2 inches on the sides, top and at the rear of the microwave oven for air circulation.
CHOOSING A LOCATION FOR YOUR MICROWAVE OVEN IF BUILT-IN
Your microwave oven can be built into a cabinet or wall by itself or above the
wall oven listed below–using:
Model# Built-in-Kit 27” Built-in-Kit 30”
GLMB209DB MWTRMKT27B MWTRMKT30B
GLMB209DS MWTRMKT27S MWTRMKT30S
GLMB209DQ MWTRMKT27Q MWTRMKT30Q
PLMB209DC MWTRMKT27C MWTRMKT30C
CPLMB209DC MWTRMKT27C MWTRMKT30C
Lower Oven: FEB27AS/B , GLEB27SCS/B, PLEB27S8CC, GLEB30S8CS/B/Q,
FEB30S5AS/B, PLEB30S8CC
Do not build-in above any other gas or electric wall oven.
• See Sketch 1 for proper location when building in above the specified wall
oven. Carefully follow both the wall oven installation instructions and
Electrolux’s Built-in Kit instructions. Be sure that the clearance of the floor
between the wall oven and the microwave oven is minimum of 2 inches.
The opening in the wall or cabinet must be within the following dimensions:
A HEIGHT : 16 3/4" to 17"
B WIDTH : 24 3/8" to 24 11/16"
C DEPTH : minimum 20"
• Outlet should NOT be in the shaded area as indicated on Sketch 2. If the
dimension of DEPTH (C) is more than 21", the outlet location may be any
area on the rear wall.
• The floor of the opening should be constructed of plywood strong enough to
support the weight of the microwave oven and floor load (about 100
pounds). The floor should be level for proper operation of the microwave
oven. Be sure to check the local building code as it may require that the
opening be enclosed with sides, ceiling and rear partition. The proper
functioning of the microwave oven does not require the enclosure.
The kit includes all the neccessary parts and easy-to-follow instructions for
installation as well as location of the power supply.
The ease of assembly for these kits will allow installation into an existing wall
opening in less than an hour if power outlet is already properly located.
Sketch 1
2"
Sketch 2
C
4"
4"
6"
A
B