Filter
Top Products
11
The portable dishwasher must be connected to a faucet and electrical outlet each time it is used. Follow directions on this
page to properly connect dishwasher.
IMPORTANT: Make sure door is latched before moving dishwasher.
The power cord and faucet coupler with hoses are located in a compartment in back of
dishwasher. A special adapter must be installed on faucet before you can connect
dishwasher (Figure A).
1. Remove faucet adapter assembly from literature package.
2. Unscrew existing sink faucet aerator.
3. Check faucet spout to see if threads are inside or outside.
• If threads are on
inside
of faucet spout, use both rubber
washers.
• If threads are on
outside
of faucet spout, use one rubber washer only.
• If faucet has no threads, an adapter kit with instructions for attachment to
a non-threaded spout is available at most hardware stores.
4. Assemble faucet spout as shown in Figure A.
Connecting the Portable Dishwasher
1.Run water at faucet until it is hot. Turn off faucet.
2.Pull hoses out of compartment.
3.Push collar down and slip faucet connector onto faucet adapter (Figure B).
4.When connector snaps into place, release collar.
5.Slowly turn on hot water all the way.
6.Plug power cord into grounded outlet.
Disconnecting the Portable Dishwasher
1.When cycle has finished, unplug power cord and return it to compartment.
2.Turn off hot water.
3.Press red button on coupler to release water pressure.
4.Press down on collar to release coupler.
5.Empty remaining water from coupler and return it to compartment.
IMPORTANT: A sink spray hose can burst due to constant water
pressure while in use. If your spray hose is installed on same water
line as the dishwasher, it is your responsibility to disconnect sink's
spray hose and to plug hole.
Electrical Connection for a Portable Dishwasher
An electrical supply of 120 volts, 60 Hz, AC only, 15 amps is required. For your safety,
the dishwasher must be grounded. If there is a malfunction or breakdown, grounding
will reduce risk of electrical shock. This dishwasher has a power cord with a 3-prong
grounding plug. It must be plugged into a mating 3-prong grounding type receptacle,
installed and grounded in accordance with the National Electrical Code and any local
codes and ordinances.
Faucet Adapter Assembly
(Figure A)
Connecting the Portable
Faucet Adapter Assembly
(Figure B)
CONNECTING AND DISCONNECTING THE PORTABLE DISHWASHER
Electric Shock Hazard
Avoid fire hazard or
electrical shock. Do not
use an adapter plug,
extension cord or
remove grounding
prong from electrical
power cord. Failure to
follow this warning can
cause serious injury, fire
or death.
CAUTION