Filter
Top Products
9
SETTING OVEN CONTROLS
Temperature Conversion (Fahrenheit/
Celsius)
The electronic oven control is set to operate in °F
(Fahrenheit) when shipped from the factory. The oven
can be programmed for any temperature from 170°F to
550°F (77°C to 288°C).
To change the temperature to °C (Celsius) or from
°C to °F (control should not be in a Bake or Clean
mode):
1. Press and hold Broil pad for 7 seconds until °F or °C
appears in the display.
2. Press the Up or Down arrow pad to change °F to
°C or °C to °F.
3. Wait 5 seconds to accept the changes or press Clear
off pad to accept the changes.
Changing between 12 or 24 Hour Time of
Day Display
1. Press and hold the Clock pad for 7 seconds. After 7
seconds, “12Hr” or “24Hr” will appear in the display
and the control will beep once.
2. Press the Up or Down arrow pad to switch between
the 12 and 24 hour time of day display. The display
will show either “12Hr” or “24Hr”.
3. Wait 5 seconds or press the Clear off pad to return
to the time of day display.
4. Reset the correct time as described in To set the
Clock above. Please note that if the 24 hour time
of day mode was chosen, the clock will now display
time from 0:00 through 23:59 hours.
NOTE
If “SP” appears, the control will operate with normal
sounds and beeps. If “- -” appears, the control is in the
silent operation mode.
NOTE
The time of day must fi rst be set in order to
operate the oven.
NOTE
The clock cannot be changed while the oven is in used.
NOTE
• The indicator light located above the Timer On•Off
pad will glow while the minute timer is active.
• The minute timer does not start or stop cooking. It
serves as an extra timer in the kitchen that will beep
when the set time has run out. The minute timer
can be used alone or during any of the other oven
functions. When the minute timer is in use with any
other mode, the minute timer will be shown in the
display. To view other functions, press the function
pad for that mode.
For a silent control panel
When choosing a function, a beep will be heard each
time a pad is pushed. If desired, the controls can be
programmed for silent operation.
To tell if your oven is set for normal or silent operation
push and hold Start time pad for 7 seconds. “- -” or
“SP” appears in the display. Within 5 seconds, press
the Up or Down arrow pad to switch between normal
sound operation and silent operation mode. The display
will show either “- -” or “SP”. Wait 5 seconds to return to
normal operating mode.
To Set the Minute Timer
1. Press the Timer On•Off pad.
2. Press the Up arrow pad to increase or Down arrow
pad to decrease the time in one minute increments.
The timer can be set for any amount of time from 1
minute to 11 hours and 59 minutes.
3. The display shows the timer count down in minutes
if more than 1 hour remains. When less than 1 hour
remains, the display will count down in seconds.
4. When the set time has run out, the timer will beep
3 times. It will continue to beep 3 times every 8
seconds until the Timer On•Off pad is pressed.
To set the Clock
When the range is fi rst plugged in, or when the power
supply to the appliance has been interrupted, the display
will fl ash “12:00”.
1. Press the Clock pad once (do not hold pad down).
2. Within 5 seconds, push and hold the Up or Down
arrow pad until the correct time of day appears in
the display.
3. Press the Clock pad to accept the new time of day.
If the Clock pad is not pressed, the timer will return
automatically to the new time of day after 7 seconds.
To Cancel the Minute Timer before the set time has
run out: Press the Timer On•Off pad.