Frigidaire FGHB2846LM Refrigerator User Manual


  Open as PDF
of 34
 
27
Ordering Replacement Filters
Toorderyourreplacementlters,pleasevisitouronline
store at www.frigidaire.com/store, by calling toll-free
at 877-808-4195, or by visiting the dealer where you
purchased your refrigerator. Frigidaire recommends that you
orderextralterswhenyourstinstallyourrefrigerator,and
thatyoureplaceyourltersatleastonceeverysixmonths.
Here is the product number to request when ordering:
PureSource 3
TM
Water Filter
Part #WF3CB
Water Filter (some models)
Thewaterlterislocatedatthetoprightsideofthefresh
food compartment.
Replacing the Water Filter
Ingeneral,youshouldchangethewaterltereverysix(6)
months to ensure the highest possible water quality. Water
Filter Status on the user interface prompts you to replace
thelterafterastandardamountofwater(200gallons/757
liters for PureSource 3
TM
)
hasowedthroughthesystem.
If your refrigerator has not been used for a period of time
(duringmovingforexample),changethelterbefore
reinstalling the refrigerator.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
thesystem.Systemscertiedforcystreductionmaybeused
ondisinfectedwatersthatmaycontainlterablecysts.
Test & certication results:
• RatedCapacity-200gallons/757litersfor
PureSource 3
TM
iceandwaterlter
• Ratedserviceow-.50gallonsperminute
• OperatingTemp.:Min.33°F,Max.100°F
• MaximumRatedPressure-100poundspersquareinch
• RecommendedMinimumOperatingPressure:30
pounds per square inch
To replace your PureSource 3
TM
water lter:
It is not necessary to turn the water supply off to change
thelter.Bereadytowipeupanysmallamountsofwater
releasedduringthelterreplacement.
1 Turn Off the ice maker power switch.
2 Removethelterbypushingontheend/faceofthe
lter.
3 Slidetheoldwaterltercartridgestraightoutofthe
housing and discard it.
4 Unpackagethenewltercartridge.Usingthe
alignmentguide,slideitgentlyintothelterhousing
until it stops against the snap-in connector at the
back of the housing.
5 Push rmly until the cartridge snaps into
place (you should hear a click as the cartridge
engages the snap-in connector).
6 Press a drinking glass against the water dispenser
whilecheckingforanyleaksatthelterhousing.
Any spurts and sputters that occur as the system
purges air out of the dispenser system are normal.
7 Afterllingoneglassofwater,continueushingthe
system for about four minutes.
8 Turn On the ice maker.
9 Press and hold the Water Filter button on the Ice
& Water Dispenser control panel for three seconds.
When the display changes from Red to Green, the
status has been reset.
The PureSource 3
TM
iceandwaterlter
systemistestedandcertiedtoNSF/ANSI
Standards 42 and 53 for the reduction of claims
speciedontheperformancedatasheet.
More about your Advanced Water Filter
NOTE
Whenorderingyourreplacementlter,pleasereorder
thesameltertypethatiscurrentlyinyourrefrigerator.
CHANGING THE FILTER
 previous next