Filter
Top Products
7
OPERATING INSTRUCTIONS
Status Indicator Lights
The CLEAN light will come on at the end of the cycle.
When the door is opened at end of cycle and remain on for
30 seconds after door is opened.
When the SANITIZE option is selected, the SANITIZED light
will glow when the SANITIZE cycle is finished and remain
on for 30 seconds after the door is opened. If the
dishwasher did not properly sanitize the dishes, the light
will not come on. This can happen if the cycle is
interrupted or if incoming water temperture is below
120
o
F.
PF……………… Appears in window when
dishwasher is first
installed, or when power
has been interrupted. HI-
TEMP WASH and AIR
DRY indicator lights will
also flash. To clear,
touch START/CANCEL
pad.
1H-24H……….. Number of delay start
hours. Count down are in
hours.
Cd……………… Close dishwasher door.
The status indicator
lights will also flash to
indicate current cycle
status.
MINUTES…...… Number of minutes left in
cycle (1-99). If cycle is
longer than 99 minutes,
the 99 will stay on until
the time counts below
99.
In the unlikely event the dishwasher malfunctions, the
indicator may display one of the following codes "Er", or
"CE". If one of these codes are displayed contact the
Frigidaire Customer Care Center at 1-800-944-
9044
They will be able to provide assistance in
troubleshooting the problem and/or locating an authorized
service technician, if needed.
NOTE
The wash cycle time could suddenly increase or drop
several minutes. This means the Smart Sensor has
checked the soil level and determined if additional water
fills are needed or if water fills can be deleted.
The Washing Light comes on at the beginning of cycle and
remains on until end of cycle.
Lo.......… Appears in window when
the rinse aid is low and
needs to be refilled.