Frigidaire FGHS2631PF2 Refrigerator User Manual


 
21
CHANGING THE FILTER
Do not use with water that is microbiologically
unsafeorofunknownqualitywithoutadequate
disinfection before or after the system.
Systemscertiedforcystreductionmaybe
used on disinfected waters that may contain
lterablecysts.
Test & certication results:
• Rated Capacity - 200 gallons/757 liters for
PureSource Ultra
TM
iceandwaterlter
• Ratedserviceow-.50gallonsperminute
• Operating Temp.: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds per
squareinch
• Recommended Minimum Operating
Pressure:30poundspersquareinch
To replace your water lter:
It is not necessary to turn the water supply off
tochangethelter.Bereadytowipeupany
small amounts of water released during the
lterreplacement.
1 Turn Off the ice maker.
2 Removethelterbypushingontheend/
faceofthelter.
3 Slidetheoldwaterltercartridgestraight
out of the housing and discard it.
4 Unpackagethenewltercartridge.Using
the alignment guide, slide it gently into
thelterhousinguntilitstopsagainst
the snap-in connector at the back of the
housing.
5 Pushrmlyuntilthecartridgesnapsinto
place (you should hear a click as the
cartridge engages the snap-in connector).
6 Press a drinking glass against the water
dispenser while checking for any leaks at
thelterhousing.Anyspurtsandsputters
that occur as the system purges air out of
the dispenser system are normal.
More about your Advanced
Water Filter
The PureSource Ultra
TM
ice
andwaterltersystemistested
andcertiedtoNSF/ANSI
Standards 42 and 53 for the
reductionofclaimsspeciedon
the performance data sheet.
7 Afterllingoneglassofwater,continue
ushingthesystemforaboutfour
minutes.
8 Turn On the ice maker.
9 Press and hold the Water Filter button
on the Ice & Water Dispenser control
panel for three seconds. When the display
changes from “Red” to “Green,” the status
has been reset.