Frigidaire FGMV173KB Microwave Oven User Manual


 
24
CLEANING AND CARE
CHARCOAL FILTER
Charcoal Filter, which was installed in your microwave oven, is
used for nonvented, recirculated installation. The filter should
be changed every 6 to 12 months depending on use.
1. Disconnect power to the microwave oven at the circuit
breaker panel or by unplugging.
2. Remove three Hood Louver screws.
3. Tilt the Hood louver downward then pull it out so bottom
tabs become unlocked.
4. Pull the Charcoal Filter upward to remove from your
oven.
5. Attach the Charcoal Filter to the upper side of the oven
by sliding into the tabs.
6. Carefully push the louver back into place and replace
the screws removed in step 2.
WORK LIGHT AND NIGHT LIGHT
1. To replace light bulbs, first disconnect power to the
microwave oven at the circuit breaker panel or by
unplugging.
2. To release cover, remove the screw on the light cover.
(See illustration.)
3. Replace light bulbs with equivalent watt bulb available
from parts distributor. Bulbs are also available at most
hardware stores or lighting centers. DO NOT USE A BULB
LARGER THAN 20 WATTS.
4.
Close light cover and secure with screw removed in step 2.
Disconnect the power cord before cleaning or
leave the door open to deactivate the oven during cleaning.
CAUTION
Light Cover may become very hot. Do not press glass
when light is on.
Light cover
Screw
Light bulbs
MICROWAVE OVEN LIGHT
Remove the louver per instructions 1-3 above and charcoal
filter, if used.
1.
To replace light bulb, first disconnect power to the microwave
oven at the circuit breaker panel or by unplugging.
2. Open light cover located behind filter mounting by
carefully pulling up on the front edge.
3. Remove old light bulb and replace only with equivalent
watt bulb available from parts distributor. Bulbs are also
available at most hardware stores or lighting centers.
DO NOT USE BULB LARGER THAN 20 WATTS.
4.
Replace the microwave oven light cover by carefully
pushing into place. Replace the charcoal filter, if used.
Push the louver back into place (engaging both the bottom
and top tabs) and replace the louver mounting screw.
Oven light
Hood louver
Charcoal lter
Bottom tab
Hood louver
Scrrews
Charcoal lter
Tabs
Tabs